Systems of Control - ConSys
official distributor of Orscheln Europe
Systems of Control – ConSys will provide your enterprise with electronic control pedals of the engine accelerator according to the Euro-3 and Euro-4 requirements
The mode settings in usual engine control systems are provided by the influence on the accelerator pedal which is mechanically connected with the fuel pump of high pressure in diesel engine. The effort from an accelerator pedal to the fuel pump of the high pressure is usually transferred through the remote control cable and sometimes by means of mechanical draughts in the earlier constructions. But there are no installed control cables and furthermore mechanical draughts in the modern engine control system.
The pressing pedal efforts of a driver are fixed by the pedal’s position sensors and then they are transferred to the electronic control box in form of the electric signals depending on angular pedal’s position. The contactless sensor with Hall effect of our pedals enables to get the characteristics which are the function of angular position of a pedal. In case of basic sensor failure there can be installed the additional sensors for the protective or diagnostic purposes.
The input and output pressure characteristics are set during the pedals manufacturing and they are presented in the form of schedules for calculations of a travel or angular pedal moving. It can be additionally installed the kick-down mode sensor for the vehicles having automatic transmission.
Sensor operating principle:
NON-CONTACT SENSOR:
Hall Effect = No Contacting parts
Not affected by lateral force
Not affected by environment
Programmable output signals
SENSOR life : >80,000,000
Switch position +/-1%
Floor Mounted Pedals:
30° angle small foot print ëèáî 38° angle
Suspended Pedals:
Polymer Sensor Integrated Direct Drive ëèáî Polymer Direct Drive
Download the catalogue
